Sceptre X42BV-FullHD User Manual download pdf (Page 40)

SCEPTRE X42 HDTV User Manual

- 40 -

www.SCEPTRE.com

If You Want the good Connection with VGA

(Analog)…

1. Make sure the power of X42 LCD HDTV and your PC is turned off.

2. Obtain a 15-pin D-Sub VGA cable, connect to the VGA output of

your PC and the other end to the VGA port off the back of your X42

LCD HDTV.

3. Obtain a 3.5 mm Mini-jack, connect to the audio out of your PC and

the other end to the VGA Stereo Input port.

4. Turn on the power of the X42 LCD HDTV and your PC.

5. Use the remote control’s source button or the source button on the

right side of the TV to switch to VGA.

Please Note :

• For the best picture, please set your PC resolution to

1920x1080 at 60 Hz. Please refer to the PC or graphic

card’s manual for further instructions on how to set your

resolution and refresh rate.

• Please refer to your PC manual for video output

requirements of the video card.

• The VGA port of the TV features a power saving mode which

will automatically turn off the TV, if there’s no signal provided

for more than 15 minutes.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 127 128

No comments

Sceptre X42BV-FullHD User Manual Page 40